7-25-00 Steering
| Early
Part Number |
Late
Part Number |
Description |
Price |
Core
Charge |
| 7-25-01 |
7-25-01 |
STEERING
BOX ASSEMBLY, REBUILT-Sits under gas tank in trunk, back connects to
steering wheel column. Core charge of $30.00 refunded upon receipt of
rebuildable core. |
$501.15 |
$30.00 |
| 7-25-02 |
7-25-02 |
U-JOINT-One
end fastens to end of steering wheel shaft, other to steering box. |
$71.80 |
$0.00 |
| 7-25-03 |
7-25-03 |
RUBBER
SEAL BOOT-Seals bottom of steering box at trunk floor under gas tank. |
$43.69 |
$0.00 |
| 7-25-04 |
7-25-04 |
METAL
FLANGE-To fasten rubber seal boot on trunk floor. |
$10.25 |
$0.00 |
| 7-25-05 |
7-25-05 |
CLAMP-Seals
bottom of rubber seal boot neck 7-25-03 on steering box. |
$2.79 |
$0.00 |
| 7-25-06 |
7-25-06 |
LOWER
CONTROL ARM-Mounts directly on bottom of steering box under hull. It is
secured by castle nut 7-25-07. |
$90.61 |
$0.00 |
| 7-25-07 |
7-25-07 |
CASTLE
NUT-Tightens lower control arm 7-25-06 on bottom of steering box shaft. |
$2.90 |
$0.00 |
| 7-25-08 |
7-25-08 |
COTTER
PIN-For castle nut 7-25-07. |
$0.66 |
$0.00 |
| 7-25-09 |
7-25-09 |
BOLT-Fastens
u-joint 7-25-02 on steering box. |
$2.09 |
$0.00 |
| 7-25-10 |
7-25-10 |
NUT-For
above bolt 7-25-09. |
$0.30 |
$0.00 |
| None |
7-25-11 |
LOCK
NUT-For above bolt 7-25-09. |
$2.09 |
$0.00 |
| 7-25-12 |
7-25-12 |
BOLT-Three
required to fasten steering box to body. |
$1.00 |
$0.00 |
| 7-25-13 |
7-25-13 |
TOOTH
WASHER-With above bolt 7-25-12. |
$0.25 |
$0.00 |
| 7-25-14 |
7-25-14 |
NUT-With
above bolt 7-25-12. |
$0.37 |
$0.00 |
| 7-25-15 |
7-25-15 |
LOCK
WASHER-With nut below, 7-25-16. |
$0.25 |
$0.00 |
| 7-25-16 |
7-25-16 |
NUT-Eight
are used to seal steering box water boot on body. |
$0.30 |
$0.00 |
| 7-25-17 |
7-25-17 |
STEERING
ARM-Left wheel. Press-fitted into lower left hole in left spindle. |
$66.59 |
$0.00 |
| 7-25-21 |
7-25-18 |
STEERING
ARM-Right wheel. Same as above, except for right spindle 5-21-18a. |
$67.31 |
$0.00 |
| 7-25-19 |
7-25-19 |
CASTLE
NUT-Locks steering arms 7-25-17 and 7-25-18 on front spindle. |
$0.57 |
$0.00 |
| 7-25-20 |
7-25-20 |
COTTER
PIN-For castle nut 7-25-19. |
$0.25 |
$0.00 |
| 7-25-21 |
7-25-18 |
STEERING
ARM-See part number 7-25-18 in the late manual column above. |
$67.31 |
$0.00 |
| 7-25-18 |
7-25-21 |
WOODRUFF
KEY-For steering arms 7-25-17/18 and front wheel spindles. |
$2.57 |
$0.00 |
| 7-25-22 |
7-25-22 |
SHORT
TRACKING ROD WITH TIE ROD ENDS ON EACH END-Fits on left side of car with
one tie rod end pressed in steering arm 7-25-17 and the other tie rod
end pressed into lower control arm 7-25-06. |
$129.70 |
$0.00 |
| 7-25-24 |
7-25-23 |
LONG
TRACKING ROD WITH TIE ROD ENDS ON EACH END-Fits on right side of car
with one tie rod end pressed into steering arm 7-25-18 and the other tie
rod end pressed into lower control arm 7-25-06. |
$171.90 |
$0.00 |
| 7-25-23 |
7-25-24 |
TIE
ROD END-Left most on track rod 7-25-22. |
$42.40 |
$0.00 |
| None |
7-25-25 |
TIE
ROD END-Right most on track rod 7-25-23. |
$42.40 |
$0.00 |
| 7-25-25 |
7-25-26 |
TIE
ROD END-Fits both tracking rods 7-25-22 and 7-25-23 on the inside in the
lower control arm 7-25-06. |
$42.40 |
$0.00 |
| None |
7-25-27 |
SHORT
TRACK ROD-Same as 7-25-22, without tie rod ends installed. |
$24.40 |
$0.00 |
| None |
7-25-30 |
TRACK
ROD NUT-For left hand threads on track rod assemblies 7-25-22 and 23. |
$2.09 |
$0.00 |
| None |
7-25-31 |
TRACK
ROD NUT-For right hand threads on track rod assemblies 7-25-22 and 23. |
$2.09 |
$0.00 |
| None |
7-25-34 |
LOCKING
TAB-Locks nuts on tie rod ends on tracking rods. |
$2.96 |
$0.00 |
| 7-25-35 |
7-25-5F |
STEERING
WHEEL-Original Amphicar white steering wheel. |
$332.00 |
$0.00 |
| None |
7-25-52/1 |
STEERING
WHEEL-Minor blemish. |
$166.00 |
$0.00 |
| 7-25-38 |
7-25-55 |
HORN
BUTTON-Original Amphicar with Lubeck Castle insignia in center. |
$45.69 |
$0.00 |
| 7-25-40 |
7-25-35 |
CASTLE
NUT-For tie rod ends. |
$1.05 |
$0.00 |
| 7-25-41 |
7-25-36 |
COTTER
PIN-For tie rod end nut. |
$0.15 |
$0.00 |
| 7-25-42 |
7-25-37 |
UPPER
STEERING RACK-Adjust the desired maximum front wheel steering angle. |
$27.07 |
$0.00 |
| 7-25-43 |
7-25-38 |
LOWER
STEERING RACK BRACKET-Fastens the upper steering rack to steering frame. |
$13.10 |
$0.00 |
| None |
7-25-39 |
NUT-Four
used to mount upper and lower steering stop brackets. |
$0.31 |
$0.00 |
| None |
7-25-39a |
LOCK
WASHER-With above nut 7-25-39. |
$0.25 |
$0.00 |
| 7-25-45 |
7-25-40 |
NUT-Steering
stop adjustment. |
$0.49 |
$0.00 |
| 7-25-46 |
7-25-41 |
BOLT-Steering
stop adjustment. |
$2.65 |
$0.00 |
| 7-25-26 |
7-25-42 |
RUBBER
PROTECTION JACKET-Boat under dash, covers opening where steering column
goes through toe board. |
$20.95 |
$0.00 |
| 7-25-27 |
7-25-43 |
STEERING
WHEEL SHAFT-From steering wheel to u-joint at steering box. |
$248.79 |
$0.00 |
| 7-25-28 |
7-25-44 |
METAL
FLANGE-Left hand strip to mount rubber boot 7-25-42 on body. |
$7.45 |
$0.00 |
| 7-25-28 |
7-25-44a |
METAL
FLANGE-Right hand strip to mount rubber boot 7-25-42 on body. |
$7.45 |
$0.00 |
| None |
7-25-45 |
SCREW-Six
used to fasten passenger compartment steering wheel boot. |
$0.39 |
$0.00 |
| 7-25-30 |
7-25-46 |
WHITE
RUBBER TRIM TUBE-Surrounds steering wheel shaft at clamp which fastens
shaft to body under dash gauges. |
$10.11 |
$0.00 |
| 7-25-31 |
7-25-47 |
CLAMP-To
fasten neck of boot 7-25-42 on steering shaft 7-25-43. |
$3.49 |
$0.00 |
| 7-25-32 |
7-25-48 |
BRACKET-To
fasten steering wheel shaft to underside of dash. |
$6.11 |
$0.00 |
| 7-25-33 |
7-25-49 |
BOLT-For
above bracket 7-25-48. |
$0.29 |
$0.00 |
| 7-25-34 |
7-25-50 |
LOCK
WASHER-For above bracket 7-25-48. |
$0.25 |
$0.00 |
| None |
7-25-51 |
CABLE
CLAMP-Fastens turn signal wire harness to body at steering wheel. |
$1.19 |
$0.00 |
| 7-25-35 |
7-25-52 |
STEERING
WHEEL-See description under early manual number 7-25-35 above. |
$232.30 |
$0.00 |
| 7-25-36 |
7-25-53 |
WOODRUFF
KEY-For steering wheel alignment slot. |
$2.85 |
$0.00 |
| 7-25-37 |
7-25-54 |
NUT-Visible
under horn button to lock steering wheel on shaft. |
$4.85 |
$0.00 |
| 7-25-38 |
7-25-55 |
HORN
BUTTON-See description under early manual number 7-25-38 above. |
$45.69 |
$0.00 |
| 7-25-39 |
7-25-56 |
WHITE
RUBBER PROTECTION SLEEVE-Between dash and back of steering wheel. |
$5.25 |
$0.00 |
| None |
7-25-57 |
NUT-Locking
nut for steering gear adjustment on top of steering box. |
$2.31 |
$0.00 |
| None |
7-25-81 |
WHEEL
RIM-4 1/2 J x 13, five hole pattern wheel painted ivory. |
$119.13 |
$0.00 |
| None |
7-25-81R |
REPLACEMENT
WHEEL RIM, SIZE 5J x 13-Originally supplied to Mercedes-Benz in Europe,
this wheel is identical in every way except is 1 inch wider and has a
higher weight carrying capacity. The original Amphicar hub cap snaps in
place exactly as on original. Note: Before mounting on rear hub, be sure
rim with tire will clear fender. This is especially important when doing
lower fender body work, or when mounting an over sized tire for better
sand traction. An ideal spare tire rim. |
$64.73 |
$0.00 |
| None |
7-25-82/640 |
WIDE
WHITE WALL TIRE-Our 640 x 13 tire is almost an exact copy of the
original Vredestein "l965 - 1968" design. It faithfully
duplicates the five grove pattern of the Vredestein. Has 2 1/2 inch wide
white wall. |
$111.90 |
$0.00 |
| None |
7-25-82/650 |
WIDE
WHITE WALL TIRE-Our 650 x 13 tire is the famous "Coke Classic".
It is an economical, high quality replacement tire to the original. It
is identical to the 640 x 13, except it has four grooves and does not
have the side design detail ribbing where the side wall meets the bottom
tread. |
$89.95 |
$0.00 |
| None |
7-25-83 |
INNER
TUBE-For all bias or radial tires mounted on original wheel rims. Note
tubeless tires must have tubes as Amphicar rims do not have the inner
safety metal lip. |
$10.35 |
$0.00 |
| None |
7-25-83a |
VALVE
STEM SEAL CAP-Screws on valve stem to prevent residual air loss. |
$0.79 |
$0.00 |
| None |
7-25-84 |
WHEEL
RIM MOUNTING NUT-Original Amphicar ball seat type to mount wheel rims on
front and rear hubs. |
$2.69 |
$0.00 |
