2-16-00
Transmission Bearings, Seals, Geras, Syncros
| Early
Part Number |
Late
Part Number |
Description |
Price |
Core
Charge |
| 2-16-01 |
2-16-01 |
DRIVE
SHAFT COMPLETE-With 3rd and 4th gear wheels. Note: you must also order
drive gear wheel 2-16-07 for water transmission. |
$342.64 |
$0.00 |
| 2-16-02 |
2-16-02 |
NEEDLE
BEARING-Goes on middle of drive shaft 2-16-01, half way between water
transmission and clutch. |
$73.44 |
$0.00 |
| 2-16-03 |
2-16-03 |
LOCKING
TAB-Locks above bearing in transmission case. |
$4.75 |
$0.00 |
| 2-16-04 |
2-16-04 |
OIL
SEAL-Seals drive shaft at clutch end of transmission housing. This black
seal has a long neck, which reaches about a fourth of an inch farther
down the shaft than an ordinary seal. The seal prevents hypoid oil from
leaking out on clutch. |
$15.50 |
$0.00 |
| 2-16-05 |
2-16-05 |
FRONT
DRIVE SHAFT BALL BEARING- |
$26.75 |
$0.00 |
| 2-16-06 |
2-16-06 |
FRONT
DRIVE SHAFT OIL SEAL-This seal prevents the hypoid oil of the water.
transmission from draining past the drive shaft into the land
transmission. |
$17.95 |
$0.00 |
| 2-16-07 |
2-16-07 |
EARLY
DRIVE GEAR-For transmissions up to serial no. 2225. Gear has splines to
slide on early drive shaft 2-16-01. |
$90.15 |
$0.00 |
| None |
2-16-07a |
LATE
DRIVE GEAR-For transmissions after serial no. 2226. Gear has keyway
slot. |
$80.90 |
$0.00 |
| 2-16-08 |
2-16-08 |
LOCKING
PLATE-To lock gear 2-16-07 on drive shaft 2-16-01. |
$3.75 |
$0.00 |
| 2-16-09 |
2-16-09 |
NUT-On
water transmission end of drive shaft 2-16-01. |
$2.19 |
$0.00 |
| 2-16-10 |
2-16-10 |
RING
GEAR AND PINION SHAFT ASSEMBLY 2-17-02 2-17-12. |
$429.00 |
$0.00 |
| 2-16-11 |
2-16-11 |
TRANSMISSION
BEARING-One of two special pinion shaft bearings made only for Amphicar.
This one fits on rear of pinion main shaft where shaft goes on ring
gear. This bearing is not manufactured and the remaining supply is very
limited. |
$199.85 |
$0.00 |
| 2-16-12 |
2-16-12 |
KEYWAY
FOR RING GEAR- |
$0.77 |
$0.00 |
| 2-16-13 |
2-16-13 |
REVERSE
IDLER GEAR-Mounts on pinion shaft. |
$49.15 |
$0.00 |
| 2-16-14 |
2-16-14 |
NEEDLE
BEARING SET-1st, 2nd, 3rd, and 4th gear cluster gears ride on this
bearing set on the land transmission main shaft. |
$97.59 |
$0.00 |
| 2-16-15 |
2-16-15 |
FIRST
GEAR WHEEL-Mounts on pinion shaft, just in front of reverse idler gear. |
$50.56 |
$0.00 |
| 2-16-16 |
2-16-16 |
PAWL
SEGMENT- |
$8.49 |
$0.00 |
| 2-16-17 |
2-16-17 |
PAWL
SEGMENT- |
$8.49 |
$0.00 |
| 2-16-18 |
2-16-18 |
PAWL
STRIP- |
$8.45 |
$0.00 |
| 2-16-19 |
2-16-19 |
SYNCRO
RING- |
$18.61 |
$0.00 |
| 2-16-20 |
2-16-20 |
HOLDING
RING-Goes on main shaft in front of 3rd gear. |
$7.95 |
$0.00 |
| 2-16-21 |
2-16-21 |
GUIDE
SLEEVE GEAR-Two per pinion shaft. |
$29.90 |
$0.00 |
| 2-16-22 |
2-16-22 |
SLIDING
SLEEVE RING-Two per pinion shaft. |
$29.79 |
$0.00 |
| 2-16-23 |
2-16-23 |
SECOND
GEAR WHEEL-Sits on pinion shaft in front of 1st gear 2-16-15. |
$49.45 |
$0.00 |
| 2-16-24 |
2-16-24 |
THRUST
WASHER-Between third gear wheel 2-16-25 and needle bearing set 2-16-14. |
$3.70 |
$0.00 |
| 2-16-25 |
2-16-25 |
THIRD
GEAR WHEEL-Not available separately. The following parts must be
replaced at the same time: 2-16-01 drive shaft, 2-16-25 3rd gear wheel
and 2-16-26 4th gear wheel. * The only exceptions are cars with
transmission serial numbers after number 2226. (Serail number is on top
of water transmission.) |
$3.70 |
$0.00 |
| 2-16-26 |
2-16-26 |
FOURTH
GEAR WHEEL-IMPORTANT, see comments above on 3rd gear wheel 2-16-25. |
$70.11 |
$0.00 |
| 2-16-27 |
2-16-27 |
PAWL
SEGMENT- |
$8.49 |
$0.00 |
| 2-16-28 |
2-16-28 |
THRUST
WASHER-Between fourth gear wheel 2-16-26 and pinion bearing 2-16-29 |
$3.69 |
$0.00 |
| 2-16-29 |
2-16-29 |
TRANSMISSION
BEARING-The other special Amphicar bearing, this one fits on front of
pinion shaft. It has large ball bearings which fit into brass races.
Very scarce, possibly more than 2-16-11. |
$239.55 |
$0.00 |
| 2-16-31 |
2-16-31 |
LOCKING
PIN-Locks left hand thread castle nut 2-16-30 on pinion front of shaft. |
$1.58 |
$0.00 |
| 2-16-32 |
2-16-32 |
REVERSE
IDLER SHAFT- |
$28.45 |
$0.00 |
| 2-16-33 |
2-16-33 |
REVERSE
IDLER GEAR- |
$56.98 |
$0.00 |
| 2-16-35 |
2-16-35 |
REVERSE
IDLER GEAR SHAFT SCREW- |
$6.99 |
$0.00 |
| 2-16-36 |
2-16-36 |
SLIDING
DRIVE GEAR-Fits on center shaft and drives water transmission gears
forward or backward. |
$125.55 |
$0.00 |
| 2-16-37 |
2-16-37 |
NEEDLE
BEARING-Fits on the center water transmission shaft. Drives gear
2-16-36, |
$31.70 |
$0.00 |
| 2-16-38 |
2-16-38 |
DISTANCE
BUSHING-Fits on center bearing pin 2-16-39, with one needle bearing
2-16-37 at each end. |
$10.09 |
$0.00 |
| 2-16-39 |
2-16-39 |
BEARING
PIN SHAFT-Different needle bearings rotate on these shafts in the water
transmission. three per transmission. |
$23.25 |
$0.00 |
| 2-16-40 |
2-16-40 |
THRUST
WASHER-Front of center shaft in water transmission. |
$5.45 |
$0.00 |
| 2-16-41 |
2-16-41 |
THRUST
WASHER-Rear of center shaft in water transmission. |
$5.45 |
$0.00 |
| 2-16-42 |
2-16-42 |
WATER
TRANSMISSION INTERMEDIATE GEAR WHEEL, LEFT HAND-One of two gears which
look almost identical, except this one has a more pronounced shoulder on
the side facing the front of the car. |
$209.00 |
$0.00 |
| 2-16-43 |
2-16-43 |
WATER
TRANSMISSION INTERMEDIATE GEAR WHEEL. RIGHT HAND -Identical to number
2-16-42, except it has no shoulder on side facing front of car. |
$209.00 |
$0.00 |
| 2-16-44 |
2-16-44 |
BEARING
BUSHING-One per above intermediate gears, holds gears on bearing pin
shaft and allows intermediate gears to rotate on needle bearings. |
$111.53 |
$0.00 |
| 2-16-45 |
2-16-45 |
NEEDLE
BEARING SET-For water transmission intermediate gears. Two individual
bearings. |
$52.69 |
$0.00 |
| 2-16-46 |
2-16-46 |
THRUST
WASHER-Fits on ends of bearing shafts that hold the right and left
intermediate gears. |
$5.45 |
$0.00 |
| 2-16-47 |
2-16-47 |
LOCKING
CIRCLIP-Locks the bearing bushing with the right and left intermediate
gears on the end of the bearing shaft. |
$0.79 |
$0.00 |
| 2-16-48 |
2-16-48 |
LARGE
DRIVE GEAR WHEEL-These six inch diameter gears sit at the outermost ends
on right and left sides of water transmission. |
$137.45 |
$0.00 |
| 2-16-49 |
2-16-49 |
DRIVE
WHEEL STUB-The back of this stub sticks out of the rear water
transmission case, with one on the right and left. It has four threaded
holes to mount each propeller drive shaft on transmission. |
$94.95 |
$0.00 |
| 2-16-50 |
2-16-50 |
OIL
SEAL-Fits behind water transmission large water drive gears. |
$15.50 |
$0.00 |
| 2-16-51 |
2-16-51 |
GROOVED
BALL BEARING-Four required to support the gear wheel 2-16-48 on. drive
wheel stubs 2-16-49. |
$27.90 |
$0.00 |
| 2-16-52 |
2-16-52 |
KEYWAY-For
drive wheel stub. |
$6.81 |
$0.00 |
| None |
2-16-53 |
FOURTH
GEAR WHEEL-Must be pressed on drive shaft 2-16-01, part of 2-16-26. |
$53.67 |
$0.00 |
