2-15-00
Transmission Case Pieces
| Early
Part Number |
Late
Part Number |
Description |
Price |
Core
Charge |
| 2-15-01 |
2-15-01 |
HOUSING-For
land transmission. |
$612.25 |
$0.00 |
| 2-15-02 |
2-15-02 |
BUSHING-On
each end of fork locating pin 2-15-65. |
$1.15 |
$0.00 |
| 2-15-03 |
2-15-03 |
DRAIN
PLUG SCREW-The two bottom plug type screws you remove to drain
transmission oil. |
$2.77 |
$0.00 |
| 2-15-05 |
2-15-05 |
STUD-Two
needed on front of land transmission housing. |
$3.01 |
$0.00 |
| 2-15-05 |
2-15-05a |
STUD-
Two needed on front of land transmission housing. Same as 2-15-05,
except 5mm longer. |
$3.01 |
$0.00 |
| 2-15-06 |
2-15-06 |
DIFFERENTIAL
SIDE COVER PLATE-Round steel plate on passenger rear side of land
transmission. |
$40.16 |
$0.00 |
| 2-15-07 |
2-15-07 |
TRANSMISSION
GASKET-Goes between differential housing side plate and transmission
case. |
$5.25 |
$0.00 |
| 2-15-08 |
2-15-08 |
BOLT-To
mount differential side plate on transmission. Eight needed. |
$0.51 |
$0.00 |
| 2-15-09 |
2-15-09 |
LOCK
WASHER-With above bolt 2-15-08. |
$0.28 |
$0.00 |
| 2-15-10 |
2-15-10 |
BOLT-Fill-up
oil level screw. When transmission oil flows out of this screw hole,
transmission is full of hypoid oil. One on land transmission on
differential side plate, other on face of water transmission housing. |
$0.49 |
$0.00 |
| 2-15-11 |
2-15-11 |
O-RING
FIBER WASHER-To seal fill-up level screws, 2-15-10. |
$1.05 |
$0.00 |
| 2-15-12 |
2-15-12 |
BASE
PLATE-Aluminum, one inch thick plate separating front and rear land
sections. |
$100.75 |
$0.00 |
| 2-15-13 |
2-15-13 |
BASE
PLATE GASKET-Seals the clutch side of base plate 2-15-12. |
$6.67 |
$0.00 |
| 2-15-14 |
2-15-14 |
BASE
PLATE GASKET-Seals the water transmission side of base plate 2-15-12. |
$6.67 |
$0.00 |
| 2-15-15 |
2-15-15 |
DOWEL
PIN-Aligns outer water transmission side of base plate 2-15-12. |
$2.39 |
$0.00 |
| 2-15-16 |
2-15-16 |
WATER
TRANSMISSION CASE -REAR-rear half of housing. |
$161.05 |
$0.00 |
| 2-15-17 |
2-15-17 |
WATER
TRANSMISSION CASE - OUTER COVER. |
$183.00 |
$0.00 |
| 2-15-19 |
2-15-19 |
BRACKET
FOR CLUTCH CABLE-Secures cable under water transmission. |
$6.57 |
$0.00 |
| 2-15-20 |
2-15-20 |
TRANSMISSION
DOWEL PIN-Aligns outer water transmission case on inner case. |
$1.55 |
$0.00 |
| 2-15-21 |
2-15-21 |
DOWEL
PIN-Aligns outer water transmission case on inner case. |
$1.55 |
$0.00 |
| 2-15-22 |
2-15-22 |
STUD-Ten
of twelve used to hold outer water transmission case on transmission. |
$3.05 |
$0.00 |
| 2-15-23 |
2-15-23 |
STUD-Two
longer of twelve used to hold outer water transmission case on
transmission. |
$3.05 |
$0.00 |
| 2-15-24 |
2-15-24 |
NUT-Twenty
four used through out transmission. |
$0.33 |
$0.00 |
| 2-15-25 |
2-15-25 |
SPRING
WASHER-With nut 2-15-24. |
$0.28 |
$0.00 |
| 2-15-26 |
2-15-26 |
DRAIN
PLUG SCREW-Fits on front face of water transmission to drain water
transmission Typoid oil. |
$1.66 |
$0.00 |
| 2-15-27 |
2-15-27 |
HEXAGON
SOCKET COUNTERSUNK SCREW-M8 x 45 5D. |
$5.81 |
$0.00 |
| 2-15-28 |
2-15-27a |
HEXAGON
SOCKET COUNTERSUNK SCREW-M8 x 50 5D. |
$5.90 |
$0.00 |
| 2-15-29 |
2-15-29 |
BOLT-Long
bolt on front of water transmission. |
$3.83 |
$0.00 |
| 2-15-30 |
2-15-30 |
BOLT-Two
used to fasten inner water transmission case to land transmission. |
$0.91 |
$0.00 |
| None |
2-15-31 |
LOCK
WASHER- |
$0.28 |
$0.00 |
| 2-15-32 |
2-15-32 |
BREATHER/FILLER
CAP-Two per Amphicar. One sits on top of the water transmission, the
other on top of the land transmission. |
$6.99 |
$0.00 |
| 2-15-33 |
2-15-33 |
SEAL
PLUG-Seals the three bearing pins 2-16-39 on outer water transmission
case. |
$0.81 |
$0.00 |
| 2-15-34 |
2-15-34 |
SELECTOR
ROD WATER TRANSMISSION. |
$12.13 |
$0.00 |
| 2-15-35 |
2-15-35 |
DOUBLE
SELECTOR FORK-Forks engage left and right intermediate gears. |
$27.33 |
$0.00 |
| 2-15-36 |
2-15-36 |
LOCKING
PIN-Secures water transmission double selector fork on selector shaft. |
$0.67 |
$0.00 |
| 2-15-37 |
2-15-37 |
RETAINING
BALL SCREW PLUG-Goes on top middle of water transmission case and holds
water transmission selector rod retaining ball under pressure. |
$8.10 |
$0.00 |
| 2-15-38 |
2-15-38 |
RETAINING
BALL-As you move water transmission lever from forward to neutral to
reverse, this-ball slips into a slot on the selector rod to keep rod
securely in place. |
$4.69 |
$0.00 |
| 2-15-39 |
2-15-39 |
SPRING-Applies
tension on selector fork 2-15-34. |
$1.11 |
$0.00 |
| 2-15-40 |
2-15-40 |
SEAL
RING-Seals selector fork 2-15-34 on rear water transmission case. |
$0.81 |
$0.00 |
| 2-15-41 |
2-15-41 |
RUBBER
SEAL-Fits on selector rods sticking out of water transmission to keep
hypoid oil from seeping out of the transmission. |
$13.75 |
$0.00 |
| 2-15-42 |
2-15-42 |
SELECTOR
ROD-For land transmission gears. |
$12.19 |
$0.00 |
| 2-15-43 |
2-15-43 |
SELECTOR
ROD-1st and 2nd gear. |
$12.19 |
$0.00 |
| 2-15-44 |
2-15-44 |
SELECTOR
ROD-3rd and 4th gear. |
$12.19 |
$0.00 |
| 2-15-45 |
2-15-45 |
SELECTOR
ROD PAWL-1st and 2nd gear. |
$9.85 |
$0.00 |
| 2-15-46 |
2-15-46 |
SELECTOR
ROD PAWL-3rd and 4th gear. |
$9.85 |
$0.00 |
| 2-15-47 |
2-15-47/47a |
SELECTOR
FORK-One used on 1st and 2nd selector rod, one on 3rd and 4th.. |
$17.35 |
$0.00 |
| 2-15-48 |
2-15-48 |
SELECTOR
ROD-Reverse gear. |
$12.19 |
$0.00 |
| 2-15-49 |
2-15-49 |
SELECTOR
ROD PAWL-Reverse gear. |
$9.85 |
$0.00 |
| 2-15-50 |
2-15-50 |
SELECTOR
FORK-Reverse gear. |
$13.36 |
$0.00 |
| 2-15-51 |
2-15-51 |
LOCKING
PIN-Six needed for various rods and pawls. |
$0.67 |
$0.00 |
| 2-15-52 |
2-15-52 |
BUSHING-Two
of three types in side of base plate 2-15-12. |
$1.36 |
$0.00 |
| 2-15-53 |
2-15-53 |
BUSHING-One
of three types in side of base plate 2-15-12. |
$1.36 |
$0.00 |
| 2-15-54 |
2-15-54 |
LOCATING
PIN-For land transmission fork. |
$0.95 |
$0.00 |
| 2-15-55 |
2-15-55 |
LOCATING
BALL-For land transmission pawls. |
$4.69 |
$0.00 |
| 2-15-56 |
2-15-56 |
LOCATING
SPRING-Applies tension on the three shift pawls during gear selection. |
$1.05 |
$0.00 |
| 2-15-57 |
2-15-57 |
PLUG
SCREW-With spring 2-15-56 and ball 2-15-55, applies tension on land gear
fork. |
$1.67 |
$0.00 |
| 2-15-58 |
2-15-58 |
PLUG
SCREW-Same as 2-15-57, except is longer. |
$1.67 |
$0.00 |
| 2-15-59 |
2-15-59 |
FIBER
WASHER-Three needed with plugs 2-15-57/58. |
$0.52 |
$0.00 |
| 2-15-60 |
2-15-60 |
PIN-On
base plate 2-15-12. |
$1.14 |
$0.00 |
| 2-15-61 |
2-15-61 |
SPEEDOMETER
GEAR-Fits inside housing 2-15-62. Speedometer cable fastens to this gear
and housing on underside of transmission. |
$44.29 |
$0.00 |
| 2-15-62 |
2-15-62 |
HOUSING
FOR SPEEDOMETER DRIVE GEAR-Aluminum housing with threads for speedometer
cable at transmission. |
$41.81 |
$0.00 |
| 2-15-63 |
2-15-63 |
CLUTCH
RELEASE LEVER-Large lever with hole at end for clutch cable. |
$43.81 |
$0.00 |
| 2-15-64 |
2-15-64 |
RETURN
SPRING-Returns clutch release lever 2-15-63 to rest position. |
$2.85 |
$0.00 |
| 2-15-65 |
2-15-65 |
LOCATING
PIN-Fastens clutch release lever 2-15-63 on transmission. |
$3.03 |
$0.00 |
| 2-15-66 |
2-15-66 |
CIRCLIP-Locks
locating pin 2-15-65. |
$0.95 |
$0.00 |
| 1-01-14 |
2-15-67 |
SPRING
CLIP-Holds the early carbon release bearing on the transmission clutch.
release lever, two required. |
$3.95 |
$0.00 |
