11-34-00 Exterior
Body Parts, Windshield, Body Seals
| Early
Part Number |
Late
Part Number |
Description |
Price |
Core
Charge |
| None |
11-34-01a |
WINDSHIELD
FRAME MEMBER-Upper metal stamping piece. Inside portion fits on top of
windshield glass. About four feet long. |
$47.90 |
$0.00 |
| None |
11-34-01P |
WINDSHIELD
METAL FRAME, PARTIAL PIECE-This is the top horizontal metal part to
which the sun visors and interior rear view mirror are fastened. |
$85.97 |
$0.00 |
| 11-34-02 |
11-34-02 |
WINDSHIELD-Original
Amphicar. |
$591.70 |
$0.00 |
| 11-34-03 |
11-34-03 |
WINDSHIELD
RUBBER FRAME-Seal of black rubber with white stripe which seals
windshield glass on car. |
$121.50 |
$0.00 |
| 11-34-04 |
11-34-04 |
COVER
FOR ENGINE PARTITION-Cover fastens to engine compartment side of
partition, allows the removal of engine or cylinder head from car. |
$18.19 |
$0.00 |
| 11-34-05 |
11-34-05 |
SCREW-Two
used to fasten engine cover partition of fire wall. |
$0.31 |
$0.00 |
| 11-34-06 |
11-34-06 |
SPEED
NUT-Above screw 11-34-05 fastens on these nuts. |
$0.73 |
$0.00 |
| 11-34-07 |
11-34-07 |
TOE
BOARD-Metal plate your feet rest on, forward of front seat. |
$84.94 |
$0.00 |
| 11-34-08 |
11-34-08 |
BOLT-Eight
used to fasten toe board to body on all Amphicars with toe boards
fastened by machine threaded 5mm bolts. |
$0.31 |
$0.00 |
| None |
11-34-08a |
SCREW-Eight
used to fasten toe board to body on all Amphicars with toe boards
fastened by sheet metal screws. |
$0.31 |
$0.00 |
| 11-34-09 |
11-34-09 |
FLAT
WASHER-To support either of above bolt/screw on toe board. |
$0.25 |
$0.00 |
| 11-34-10 |
11-34-10 |
METAL
COVER FOR TIE ROD ASSEMBLY-Fastens outside under car to protect steering
parts. |
$92.34 |
$0.00 |
| 11-34-11 |
11-34-11 |
BOLT-Eight
used to fasten tie rod/drag link protection cover to under body on all
Amphicars where cover is fastened by machine threaded 6mm bolts. |
$0.31 |
$0.00 |
| None |
11-34-11a |
SHEET
METAL SCREW-Same as 11-34-11, except on cars where cover is fastened by
sheet metal screws. |
$0.61 |
$0.00 |
| 11-34-12 |
11-34-12 |
TOOTH
WASHER-To lock above bolts 11-34-11/11a on body. |
$0.25 |
$0.00 |
| 11-34-14 |
11-34-13 |
BRASS
O-RING SEAL WASHER-Large half dollar size, seals brass bilge plug on
body. |
$2.35 |
$0.00 |
| None |
11-34-13a |
O-RING
TYPE BILGE PLUG-Has rubber o-ring around outside edge of this plug about
two inches in diameter. Fastens to body by pushing into recess on body
and locked in place by 2 3/4 inch long bolt. |
$31.77 |
$0.00 |
| 11-34-13 |
11-34-14 |
BILGE
DRAIN PLUG-Brass type screws into right rear under body. |
$22.97 |
$0.00 |
| None |
11-34-14a |
RUBBER
O-RING-Goes around outside of new large style bilge plug 11-14-13a. See
number 11-34-14f to modify your car to use the brass bilge plug 11
34-14. |
$7.99 |
$0.00 |
| None |
11-34-14b |
BOLT-To
fasten large o-ring type bilge plug on body. |
$2.50 |
$0.00 |
| None |
11-34-14c |
NUT-To
fasten bolt 11-34-14b on body. |
$0.75 |
$0.00 |
| None |
11-34-14f |
FEMALE
THREADED INSERT-This insert is welded to right rear bottom panel with
the brass bilge plug fitting in it. If the threads are stripped on your
Amphicar, installation of a new insert plus a new brass plug will keep
your bilge dry. |
$26.65 |
$0.00 |
| None |
11-34-15 |
HINGE,
FRONT HOOD LEFT. |
$53.45 |
$0.00 |
| None |
11-34-16 |
HINGE,
FRONT HOOD RIGHT. |
$53.45 |
$0.00 |
| 11-34-17 |
11-34-17 |
HINGE
PIN-Fastens front hood hinge on body. |
$3.80 |
$0.00 |
| 11-34-18 |
11-34-18 |
SPRING
WASHER-Two used on each hinge pin. |
$0.24 |
$0.00 |
| 11-34-19 |
11-34-19 |
FLAT
WASHER-One used per hinge pin. |
$0.25 |
$0.00 |
| 11-34-20 |
11-34-20 |
COTTER
PIN-For hinge pin 11-34-17. |
$0.25 |
$0.00 |
| None |
11-34-21 |
HINGE
ASSEMBLY, REAR ENGINE COVER-Two required. |
$56.90 |
$0.00 |
| 11-34-22 |
11-34-22 |
BOLT-Eight
used to fasten rear engine cover hinge on body. |
$0.39 |
$0.00 |
| 11-34-23 |
11-34-23 |
LOCK
WASHER-For above bolt 11-34-22. |
$0.25 |
$0.00 |
| 11-34-25 |
11-34-25 |
BODY
AT HOOD OPENING, BOTTOM WEATHERSTRIP-This hood weatherstrip fastens on
the body to seat front hood from waves and spray. Also see 11-39-11 for
upper hood weatherstrip. For correct glue, see last page under 3M-1. |
$54.60 |
$0.00 |
| 11-34-26 |
11-34-26 |
REAR
SEAT INSULATION BASE-Pressed, moulded panel upon which rear seat sits.
Keeps engine noise and heat from entering passenger compartment. |
$381.00 |
$0.00 |
| None |
11-34-27 |
SCREW-Two
needed on some cars to fasten rear seat base to body. |
$0.31 |
$0.00 |
| 11-34-28 |
11-34-28 |
CONCAVE
REINFORCEMENT WASHER-Used under sheet metal screws when fastening rear
seat base to body above transmission. |
$0.29 |
$0.00 |
| None |
11-34-30 |
RUBBER
EDGE COVER-For front edge of rear seat base. |
$13.05 |
$0.00 |
| None |
11-34-31 |
RUBBER
EDGE COVER-For rear edge of rear seat base. |
$11.35 |
$0.00 |
| 11-34-32 |
11-34-32 |
WEATHERSTRIP-Rear
seat platform base rests on this weatherstrip, which is glued to body.
Fits. entire outer edge of rear seat cavity. |
$31.31 |
$0.00 |
| 11-34-33 |
11-34-33 |
BODY
AT DOOR WEATHERSTRIP-Glues to body and seals against door rubber seal
11-36-48 when door is closed. For correct glue, see last page under
3M-1. |
$23.95 |
$0.00 |
| 11-34-34 |
11-34-34 |
WHITE
PLASTIC PROTECTION STRIP-Covers door sill weld and up both sides of door
opening. For correct glue, see last page under 3M-1. |
$31.99 |
$0.00 |
| 11-34-35 |
11-34-35 |
CHROME
END CLIP-Goes on ends of white plastic protection strip which covers
door sill opening. |
$1.02 |
$0.00 |
| 11-34-36 |
11-34-36 |
BLACK
RUBBER PUSH CAP-Covers screw access holes in body, for rear window
regulator screws on each side post and one more on front post. |
$1.59 |
$0.00 |
| None |
11-34-37 |
REAR
SEAT CENTER BRACE-Fits over top of water transmission. Back of this two
inch wide brace fastens to center of convertible top boot panel. Front
fastens to rear seat metal partition, brace supports rear seat base
11-34-26. |
$25.14 |
$0.00 |
| None |
11-34-38 |
CARPET
KNOB-Two of these black plastic knobs are fastened to toe board. A
slightly smaller hole in rubber floor mat allows mat to remain firmly in
place. On some models, snaps 12-45-28/28b are used. |
$1.39 |
$0.00 |
| None |
11-34-40 |
SCREW-Sheet
metal screw fastens front edge of rear seat platform base 11-34-26 to
body. Also fastens rear seat platform brace on body. |
$0.31 |
$0.00 |
| None |
11-34-41 |
SUPPORT
WASHER-Provides strength where screw 11-34-40 fastens seat brace bracket
11-34-37 to body. |
$0.25 |
$0.00 |
| None |
11-34-42 |
SCREW-Three
used to fasten rear edge of rear seat platform base on body. |
$0.71 |
$0.00 |
| None |
11-34-43 |
FRONT
SUSPENSION AXLE FRAME-Four foot long tube welded to body between front
wheels. Swing arm solid front axles fit inside ends of tube. |
$383.92 |
$0.00 |
| None |
11-34-44 |
STEERING
BOOT BASE-Metal plate boot studs are welded to body. Steering box lower
shaft goes through this base with rubber seal boot seated through studs. |
$38.46 |
$0.00 |
| None |
11-34-45 |
SHEET
METAL POCKET BOTTOM PLATE-See description under 12-50-11. |
$32.10 |
$0.00 |
